2014年1月19日星期日

最近作成したCisco 642-691認定試験の優秀な過去問

JPexamを通してCisco 642-691試験に合格することがやすくて、Cisco 642-691試験をはじめて受ける方はJPexamの商品を選んで無料なサンプル(例年の試験問題集と解析)をダウンロードしてから、楽に試験の現場の雰囲気を体験することができます。オンラインにいろいろなCisco 642-691試験集があるですけれども、弊社の商品は一番高品質で低価額で、試験の問題が絶えず切れない更新でテストの内容ともっとも真実と近づいてお客様の合格が保証いたします。それほかに、弊社の商品を選んで、勉強の時間も長くではありません。できるだけ早くCisco 642-691認定試験を通ろう。

いまCiscoの642-691認定試験に関連する優れた資料を探すのに苦悩しているのですか。もうこれ以上悩む必要がないですよ。ここにはあなたが最も欲しいものがありますから。受験生の皆さんの要望に答えるように、JPexamは642-691認定試験を受験する人々のために特に効率のあがる勉強法を開発しました。受験生の皆さんはほとんど仕事しながら試験の準備をしているのですから、大変でしょう。試験に準備するときにはあまり多くの時間を無駄にすることを避けるように、JPexamは短時間の勉強をするだけで試験に合格することができる642-691問題集が用意されています。この問題集には実際の試験に出る可能性のあるすべての問題が含まれています。従って、この問題集を真面目に学ぶ限り、642-691認定試験に合格するのは難しいことではありません。

現在のネットワークの全盛期で、Ciscoの642-691の認証試験を準備するのにいろいろな方法があります。JPexamが提供した最も依頼できるトレーニングの問題と解答はあなたが気楽にCiscoの642-691の認証試験を受かることに助けを差し上げます。JPexamにCiscoの642-691の試験に関する問題はいくつかの種類がありますから、すべてのIT認証試験の要求を満たすことができます。

試験番号:642-691問題集
試験科目:CCIP BGP + MPLS Exam (BGP + MPLS)
最近更新時間:2014-01-19
問題と解答:全80問
100%の返金保証。1年間の無料アップデート。

「今の生活と仕事は我慢できない。他の仕事をやってみたい。」このような考えがありますか。しかし、どのようにより良い仕事を行うことができますか。ITが好きですか。ITを通して自分の実力を証明したいのですか。IT業界に従事したいなら、IT認定試験を受験して認証資格を取得することは必要になります。あなたが今しなければならないのは、広く認識された価値があるIT認定試験を受けることです。そうすれば、新たなキャリアへの扉を開くことができます。Ciscoの642-691認定試験というと、きっとわかっているでしょう。この資格を取得したら、新しい仕事を探す時、あなたが大きなヘルプを得ることができます。何ですか。自信を持っていないから642-691試験を受けるのは無理ですか。それは問題ではないですよ。あなたはJPexamの642-691問題集を利用することができますから。

多くのIT者がCiscoの642-691認定試験を通してIT業界の中で良い就職機会を得たくて、生活水準も向上させたいです。でも多くの人が合格するために大量の時間とエネルギーをかかって、無駄になります。同等の効果は、JPexamは君の貴重な時間とお金を節約するだけでなく100%の合格率を保証いたします。もし弊社の商品が君にとっては何も役割にならなくて全額で返金いたいます。

購入前にお試し,私たちの試験の質問と回答のいずれかの無料サンプルをダウンロード:http://www.jpexam.com/642-691_exam.html

NO.1 Based on the topology diagram shown in the exhibit, when should BGP be used as the routing protocol
between the customer and the ISP?
A. If physical link failures can not be detected by the link-level procedures.
B. If the customer wants to affect how the ISP will route the customer's traffic out to the rest of the Internet.
C. If the ISP does not support static routing with the customer.
D. If the customer is using provider-assigned (PA) addresses inside the customer's network.
E. If the customer is using private addresses inside the customer's network.
Answer: A

Cisco問題集   642-691認定証   642-691   642-691認定試験

NO.2 For which purpose is the command mpls ldp maxhops used?
A. In large ATM-MPLS networks, the LFIB can become too large and it may be necessary to limit the
maximum diameter of the MPLS LSPs.
B. Because downstream-on-demand label allocation uses hop count to control loop detection, it maybe
necessary to limit the maximum diameter of the MPLS network.
C. Because end-to-end delay can cause problems with some voice applications, it may be necessary to
limit the maximum diameter of the MPLS network.
D. When interconnecting large frame mode MPLS and cell mode networks it may be necessary to limit the
maximum network diameter to prevent forwarding loops.
Answer: B

Cisco   642-691   642-691   642-691参考書

NO.3 What does the following command accomplish?
sanjose#clear ip bgp 10.1.1.1 in prefix-filter
A. The sanjose router will perform an outbound soft reconfig to the 10.1.1.1 neighbor.
B. The sanjose router will send out the ORF prefix-list so that a new route refresh will be received from the
1.1.1 neighbor.
C. The 10.1.1.1 router will perform an inbound soft reconfig on the updates from the sanjose neighbor.
D. The 10.1.1.1 router will send out the ORF prefix-list so that a new route refresh will be received from
the sanjose neighbor.
E. The bgp session between the sanjose and the 10.1.1.1 router will be reset so that all the new bgp
updates from the 10.1.1.1 router can be processed by the inbound prefix-list at the sanjose router.
F. The bgp session between the sanjose and the 10.1.1.1 router will be reset so that all the new bgp
updates from the sanjose router can be processed by the inbound prefix-list at the 10.1.1.1 router.
Answer: B

Cisco認定証   642-691   642-691

NO.4 Refer to the diagram.
What problem can be caused by the second P router summarizing the loopback address of the egress PE
router.?
A. The first P router will be faced with a VPN label which it does not understand.
B. The second P router will be faced with a VPN label which it does not understand.
C. The egress PE router will not be able to establish a label switch path (LSP) to the ingress PE router.
D. A label switch path (LSP) will be established from the ingress PE router to the egress PE router, an
event that is not desirable.
E. The ingress PE router will not be able to receive the VPN label from the egress PE router via MP-IBGP.
Answer: B

Cisco   642-691   642-691参考書   642-691練習問題

NO.5 What are three drawbacks of a peer-to-peer VPN using a shared provider edge (PE) router? (Choose
three.)
A. A full mesh of virtual circuits is required between the customer sites.
B. All the customers have to share a common IP address space.
C. Optimal routing between customer sites cannot be guaranteed.
D. The shared PE router has to know all routes for all customers.
E. Packet filters are required on the PE routers.
Answer: BDE

Cisco認定証   642-691参考書   642-691   642-691   642-691認証試験

NO.6 In a central services topology, which routes do client VRFs contain?
A. routes from the client site, but not from the server site
B. routes from the server site, but not from the client site
C. routes from both the client site and the server site
D. only EBGP routes from either the client site or the server site
Answer: C

Cisco   642-691参考書   642-691   642-691過去問   642-691認定証   642-691

NO.7 Refer to the exhibit.
\Which two of the following statements about the MPLS configurations are true? (Choose two.)
A. The VPI range being configured is the default VPI range.
B. The router is missing the mpls label protocol ldp configuration command on its ATM 0/0.1 subinterface
to make it an LC-ATM enabled subinterface.
C. There is a problem with the configurations because the control VC should be set to 0 32 instead.
D. The ATM switch is using VC merge since VC merge is enabled by default.
E. For MPLS label allocations, both VPI 6 and 7 can be used.
Answer: DE

Cisco   642-691練習問題   642-691

NO.8 Based on the network diagram shown in the exhibit, what is the correct configuration on the customer
edge router used to conditionally announce the customer networks to the ISP?
A. router bgp 65001
! neighbor commands not shown
network 192.168.8.0 mask 255.255.252.0
!
ip route 192.168.8.0 255.255.252.0 192.168.8.33
B. router bgp 65001
! neighbor commands not shown
aggregate-address 192.168.8.0 255.255.252.0 summary-only
!
ip route 192.168.8.0 255.255.252.0 192.168.8.33
C. router bgp 65001
! neighbor commands not shown
network 192.168.8.0
network 192.168.9.0
network 192.168.10.0
network 192.168.11.0
!
ip route 192.168.8.0 255.255.255.0 null0
ip route 192.168.9.0 255.255.255.0 null0
ip route 192.168.10.0 255.255.255.0 null0
ip route 192.168.11.0 255.255.255.0 null0
D. router bgp 65001
! neighbor commands not shown
aggregate-address 192.168.8.0 255.255.252.0 summary-only
!
router ospf 1
network 192.168.8.0 0.0.3.255 area 0
E. router bgp 65001
! neighbor commands not shown
aggregate-address 192.168.8.0 255.255.252.0
!
ip route 192.168.8.0 255.255.252.0 null0
Answer: A

Cisco問題集   642-691   642-691

NO.9 Which two of the following statements regarding LDP are true? (Choose two.)
A. LDP can also be used between nonadjacent routers using multicast LDP hello messages.
B. LDP does not require periodic hello messages once the LDP session has been established between
the LDP peers.
C. LDP hello messages use TCP packets with a destination port number of 646.
D. Multiple sessions can be established between a pair of LSRs if they use multiple label spaces.
E. Per-platform label space can be identified by a label space ID of 0 in the LDP identifier field.
Answer: DE

Cisco   642-691過去問   642-691   642-691

NO.10 On a dedicated subinterface implementation, PE-2 must establish an address-family vrf IPv4 BGP
neighbor relationship with which router?
A. CE-1
B. CE-2
C. PE-1
D. PE-IG
E. CE-1 and CE-2
F. PE-1 and PE-IG
Answer: B

Cisco   642-691   642-691参考書   642-691   642-691

JPexamは最新の000-455問題集と高品質の074-409問題と回答を提供します。JPexamのHP3-C33 VCEテストエンジンとC_TFIN52_64試験ガイドはあなたが一回で試験に合格するのを助けることができます。高品質のVCAD510 PDFトレーニング教材は、あなたがより迅速かつ簡単に試験に合格することを100%保証します。試験に合格して認証資格を取るのはそのような簡単なことです。

記事のリンク:http://www.jpexam.com/642-691_exam.html

没有评论:

发表评论